Safe Pallet Racking - Is Your Pallet Racking Certified?

Each most important questions you need to ask a yourself before you acquire your Warehouse Racking systems:

  • 1 . Does your pallet racking meet the Australian Standards?
  • 2 . Has your pallet racking been certified?

These are very good questions, because there is more that will pallet racking than meets the eye.

Australian Standards

Aussie Standards are established to protect consumers against cheap unfavorable products being made locally or imported and pallet racking is no exception. The Australian Standard defines the least requirements for the design, fabrication, and erection tolerances, test solutions, operation, and maintenance of pallet racking. In regards to Pallet Racking you must ensure the product has been tested and rated in agreement with Australian Standard AS4084-1993. A lot of importers fall into the lock in of claiming that their pallet racking is skilled by their supplier when in fact they need to hold the record themselves. The danger is that quite often the testing has been produced by the supplier overseas and not done by a certified Australian tests facility. The danger therefore is that they may have tested only analyzed part of their range and subsequently the Racking people but will not meet those standards.

Certified

On the other hand being sure that the racking has been locally certified will give you and your workforce a complete level of security as not only is every point tested but given a load rating as well. The largest examining facility in Australia is the Monash University and they will required product what's called

EVALUATION OF ENGINEERING PROPERTIES WITH PALLET RACKING COMPONENTS IN ACCORDANCE WITH AS 4084-1993

Some of the Official certifications tests that are performed by the Monash University include...

Stub column tests

To determine the form factor (Q) of the perforate rack columns in accordance with AS 4084-1993, Clause 8. couple of for the 90x70x1. 8mm upright columns.

Pallet beam medical tests
To determine the bending Pallet Supplier in Akron beam properties in accordance with AS4084-1993, Posture 8. 3. 1 for the 100x45x1. 5 pallet smile section.

Pallet beam to column connection tests

To look for the connection moment, in accordance with AS4084-1993, Clause 8. 4. one "Cantilever test", for the 90x70 column in combination of 100x45 beams.

Portal connection tests

This test shall be useful to obtain a joint spring constant needed for semi rigid figure analysis, in accordance with AS4084-1993, Clause 8. 4. 2, "Portal test", for the same combination as in Section 1 . 4.

Code tensile tests

To determine the tensile yield strength of the product used in making the beam and column sections, the examples were taken from the column and beam sections screened.

Acquiring a certificate protects everyone, from the importer, retailer and the customer who has an obligation to supply a safe working environment. Current day's Occupational Health and Safety laws are so stringent that you would be acquiring an enormous risk if you were to purchase new or old pallet racking for your business from a supplier unable to produce a certified product.

Therefore before selecting pallet racking for your personal business, you should ensure that you are getting a certified and therefore thoroughly tested device from your supplier.

Gary Klungreseth